Making a luminous Linux logotype.

  
  After the resin has polymerized smooth the subject out with an emery paper of minimal gauge. This operation is admissible not for all surfaces, not every section can be handled and not every surface can be scratched with it… In my case the aluminium sheet should be sand-papered anyway. In your case you must decide yourself. If the logo has been cut out smartly, you don’t need glue at all, or use a minimal quantity of it…

   The result is great. The logo looks effective and shines brightly; it is not perceptible by hand palpation. People can’t understand how it was done, they touch it with hands and smile :) Don’t blame me for the quality of photographs. It’s almost impossible to make a good shot of a bright logo on shining aluminium. At least, with my camera…

You can read article about this silent PC. You may write your comments here.

I wish everyone good modding SilentMods.com. If somebody makes such modding, send us your story and photos.