Our answer to Zalman: 0dBA project, rev.1

III. Finishing strokes.
I removed everything out of the case, cut a ventilating hole in its base and covered it with a mesh; I cut it from Kamaz filter, which I bought beforehand. I stuck the mesh with Poxypol, but it’s not the best way- it sticks badly to metal, even it is processed with sand-paper, and it was periodically coming unstuck. I had to stick it with glue. Then I performed these actions with the case cover, which I cut earlier and installed it in its place.

For good convectional ventilation of the case components I needed high mounts, which I bought the next day. Then I added the finishing strokes, such as installation of an X800Pro with heat pipes and the radiator...