Modded alarm clock with six processors

    Take into consideration that the process of filing the hole is very important. Rolex must fit into the hole tightly and with a little pressure (not too much pressure), and restrain itself in the hole. I didn’t invent other means of fixing the watch as this method is good enough… Everything depends on the watch construction. May be fixing with small screws would be appropriate as well.
    I’m writing this article and reflect on it, what if a “wisehead” will mode his father’s watch :) I remind once more that we speak about cheap Rolex made in China and costing 4 dollars.
  

    While I was fixing the mechanism, I thought out an application for the broken processor. I decided to install a cool button “Reset” in the middle of it. I select samples from the debris for a nice red button.
   

     To provide a high-quality glueing together of the debris, we need a special device. It is a polished plate with threaded holes; you can see it in the picture. A ruler is placed into a thrust and performs the function of a backlash spring. So, make the preparations and fit the processor debris. Degrease, glue with epoxy adhesive and squeeze it. Wipe the surplus of the resin from the cover with spirit. A high quality glued joint must be three times thinner than a hair and inconspicuous even when being looked straight at… It’s also possible to glue it without the mentioned device having twisted the processor round with sewing; but in such case you’ll not have opportunity to clean the upper cover and the appearance will be not so nice. The dried up epoxy adhesive can’t be washed off.